Minicard display - wall / counter
Ref : G64000
Contents:
Two acrylic side panels
One pvc tiered section
Four nylon pushfit fasteners
Two wall-fix screws & cup washers
Free standing use
1) Peel off the protective polythene from both surfaces of the side panels
and both surfaces of the stepped section. You may find this easier if you
start around the holes.
2) The pvc section has a fold at the top of the stand and at the bottom
front edge. (Which by the way is perfect for slipping in your company name
and logo.) Slide the acrylic side panel in between the fold top and bottom
with the sloping edge facing forward. Fasten at all four hole points by
simply pushing through a nylon fastener from the front; they must snap into
position.
Wall fixing use
1) Peel off the protective polythene from both surfaces of the side panels
and both surfaces of the stepped section. You may find this easier if you
start around the holes.
2) The pvc section has a fold at the top of the stand and at the bottom
front edge. (Which by the way is perfect for slipping in your company name
and logo.) Slide the acrylic side panel in between the fold top and bottom
with the sloping edge facing forward. Line up the holes and fasten with two
nylon pushfit fasteners at the bottom front edge.
3) At the top edge, line up the holes, place cup washers on screws push
through the holes and secure to your wall.
Slatboard use (requires Slatwall kit Ref. X59000)
As above until 4
At the top edge, line up the holes of the tiered section and the Slawall kit
brackets and using the brass screws, push them through the holes of the
display and the brackets. The card/postcard display is now ready to fit into
your slatted board.