3D Displays Home

Click for the Display & Point of Sale Index
Click for Company Info & Carriage Charges
 Click to Request a Display & Point of Sale Catalogue

Standard card display instructions
View Current Order 3D Displays Home
  Standard card display-wall/counter
Ref : G69000

Contents:
Two acrylic side panels
One pvc tiered section
Four nylon pushfit fasteners
Four nylon screws and rods
Two metal screws and cup washers (wall fixing use)

Free standing use
1) Peel off the protective polythene from both surfaces of the side panels and both surfaces of the stepped section. You may find this easier if you start around the holes.

2) Taking the side panels ; first push a small nylon screw through each of the small holes from the outside and screw a nylon rod from the inside. These are the supports , tighten with a screwdriver if necessary

3) The pvc section has a fold at the top of the stand and at the bottom front edge. (Which by the way is perfect for slipping in your company name and logo.) Slide the acrylic side panel in between the fold top and bottom with the sloping edge facing forward, ensuring the nylon rod supports are behind each section of rack. Fasten at all four hole points by simply pushing through a nylon fastener from the front; they must snap into position.

Wall fixing use
1) Peel off the protective polythene from both surfaces of the side panels and both surfaces of the stepped section. You may find this easier if you start around the holes.

2) Taking the side panels ; first push a small nylon screw through each of the small holes from the outside and screw a nylon rod from the inside. These are the supports , tighten with a screwdriver if necessary

3) The pvc section has a fold at the top of the stand and at the bottom front edge. (Which by the way is perfect for slipping in your company name and logo.) Slide the acrylic side panel in between the fold top and bottom with the sloping edge facing forward, ensuring the nylon rod supports are behind each section of rack. Fasten at all four hole points by simply pushing through a nylon fastener from the front; they must snap into position.

4) At the top edge, line up the holes, place cup washers on screws push through the holes and secure to your wall.

Slatboard use (requires Slatwall kit Ref. X59000)

As above until 4
At the top edge, line up the holes of the tiered section and the Slatwall kit brackets and using the brass screws, push them through the holes of the display and the brackets. The card/postcard display is now ready to fit into your slatted board.