Tiered tray - wall / counter
Ref : T77000
Contents:
Two acrylic side panels
One pvc stepped section
Four nylon push fit fasteners
Four nylon washers
Two nylon screws & rods
Two metal screws & cup washers for wall fixing use
Free standing use
1) Peel off the protective polythene from both surfaces of the side panels
and both surfaces of the stepped section. You may find this easier if you
start around the holes.
2) Taking the side panels ; first push a small nylon screw through each of
the small holes from the outside and screw a nylon rod from the inside.
These are the supports , tighten with a screwdriver if necessary
3) The pvc section has a fold at the top of the stand and at the bottom
front edge. (Which by the way is perfect for slipping in your company name
and logo.) Slide the acrylic side panel in between the fold top and bottom
with the sloping edge facing forward, ensuring the nylon rod supports are
behind each section of rack. Fasten at all four hole points by simply
pushing through a nylon fastener from the front; they must snap into
position. Lastly push a nylon washer over each push fit fastener and snap
into place.
Wall fixing use
1) Peel off the protective polythene from both surfaces of the side panels
and both surfaces of the stepped section. You may find this easier if you
start around the holes.
2) The pvc section has a fold at the top of the stand and at the bottom
front edge. (Which by the way is perfect for slipping in your company name
and logo.) Slide the acrylic side panel
in between the fold top and bottom with the sloping edge facing forward,
ensuring the nylon rod supports are behind each section of rack. Fasten at
the bottom holes by simply pushing through a nylon fastener from the front;
they must snap into position. Lastly push a nylon washer over each push fit
fastener and snap into place.
3) At the top edge, line up the holes, place cup washers on the screws, push
through the holes and secure to your wall.
Slatboard use (requires Slatwall kit Ref. X59000)
As above but instead of using the push fit fasteners in the holes at the top
edge, line up the holes of the Tiered Tray with the holes in the Slatkit
brackets push through the brass screws and tighten, the tiered tray is now
ready to fit into your slatted board.