Multi merchandiser-wall/counter
Ref : T79000
Contents:
Two acrylic side panels
One pvc stepped section
Four nylon pushfit fasteners
Four nylon washers
Two wood screws & cup washers for wall fixing use
Free standing use
1) Peel off the protective polythene from both surfaces of the side panels
and both surfaces of the stepped section. You may find this easier if you
start around the holes.
2) The pvc section has a fold at the top of the stand and at the bottom
front edge. (Which by the way is perfect for slipping in your company name &
logo!) Slide the acrylic side panel in between the fold top & bottom with
the sloping edge facing forward. Fasten at all four hole points by simply
pushing through a nylon fastener from the front; they will snap together in
position. Make sure they have ‘clicked’ .Lastly push a nylon washer over
each push fit fastener and snap into place.
Wall fixing use
1) Peel off the protective polythene from both surfaces of the side panels
and both surfaces of the stepped section. You may find this easier if you
start around the holes.
2) The pvc section has a fold at the top and the bottom front edge. Slide
the acrylic side in between the fold top and bottom, with the sloping edge
facing forward. Line up the holes panel and fasten with nylon push fit
fasteners at the bottom front edge and push a nylon washer over each one to
secure.
3) At the top edge, line up the holes, place cup washers on the screws, push
through the holes and secure to your wall.
Slatboard use (requires Slatwall kit Ref. X59000)
As above but instead of using the push fit fasteners in the holes at the top
edge, line up the holes of the merchandiser with the holes in the Slatkit
brackets push through the brass screws and tighten, the merchandiser is now
ready to fit into your slatted board.